BS EN 12476 PDF

September 18, 2019   |   by admin

T5 = Application of wax. T6 = Application of soap. Supersedes;. BS EN BS AMS Phosphate treatment is defined by reference to a particular. Find the most up-to-date version of BS EN at Engineering BS EN October Phosphate conversion coatings of metals. Method of specifying requirements. Historical Version.

Author: Yozahn Kazigrel
Country: Portugal
Language: English (Spanish)
Genre: Software
Published (Last): 26 November 2018
Pages: 475
PDF File Size: 7.23 Mb
ePub File Size: 5.89 Mb
ISBN: 985-7-55013-238-3
Downloads: 8160
Price: Free* [*Free Regsitration Required]
Uploader: Mezizahn

If necessary, adjust the pH to the desired level by adding solid ammonium chloride.

A version in any other language made by translation under the responsibility of a CEN member into its own ba and notified to the Management Centre has the same status as the official versions. A comma is used as the decimal marker.

BS EN 12476:2000

If neither manganese nor zinc has been detected in a phosphate coating on a substrate of ferrous material, then the coating is certain to eh an iron phosphate coating. Previous editions DIN Use the other half of the solution to test for the presence of calcium as described in subclause NA.

  AS PUPILAS DO SENHOR REITOR PDF

The committee decided to retain the specifications of subclause 7. To decompose the excess hydrogen peroxide, boil the resulting solution for a few minutes and then cool it to ambient temperature.

Decoloration of the permanganate solution identifies the precipitate as calcium oxalate, thus indicating the presence of calcium in the coating. To identify the purified white precipitate as calcium oxalate, remove it from the filter by spraying with hot distilled water, and hs add about 50 ml of distilled water. A white precipitate, which may have a slight green tinge due to the presence of a small amount b iron, indicates the presence of zinc.

Add 10 ml of the ammonium molybdate solution and 5 g of ammonium nitrate to the acidified filtrate, and leave the mixture to stand for at least 15 minutes. Filter this off after 10 minutes of heating and rinse thoroughly with hot distilled water.

To establish that a coating is a zinc phosphate or a zinc calcium phosphate coating, it is sufficient to establish the presence of zinc 1247 zinc and calcium, respectively for zinc-free substrates cf.

  COHEN ROGERS SARAVANAMUTTOO PDF

The detection of phosphate in a coating shall be taken as proof that it is a phosphate coating cf. To establish that a coating is a manganese phosphate coating, it is sufficient to establish the presence of manganese for ferrous substrates only cf.

BS EN – Phosphate conversion coatings of metals. Method of specifying requirements

EN comprises 12 pages. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Management Centre or to any CEN member.

Using half of the solution, test for manganese by adding 0,5 g of bismuth sodium trioxide, thus oxidizing any manganese present to permanganate; a reddish violet colour indicates the presence eh manganese.

A yellow precipitate indicates the presence of phosphate. If necessary, scrub the coating off with a rubber wiper.